스틸 건축용 와셔

Nord-Lock은 심한 진동과 동적 부하에 노출될 때도 볼트 체결부의 풀림을 방지하는 쐐기형 풀림 방지 기술을 처음 개발했습니다. 볼트 헤드 아래와 너트에 만들어진 쐐기 때문에 제품의 자연적인 풀림은 불가능합니다.

Joint Guide

Nord-Lock SC-washers can be used with HV / HR bolts and nuts.

Through-holes
Through-holes require the use of two pairs of Nord-Lock SC-washers. One pair for securing the bolt and a second pair for securing the nut. Turn both fasteners in order to close the cams on both washer pairs before tightening to minimize settlements. Keep the bolt secure whilst tightening the nut.

Designs where Nord-Lock SC-washers are not recommended:

  • With chamfered plain washers.
  • Mating surfaces that are not locked in place.
  • Mating surfaces harder than the washers.
  • Extremely soft mating surfaces (e.g. wood, plastic).
  • Applications with extremely large settlements.

Torque Guidelines

Please note that the torque guidelines below are valid for HV bolts only.

Washer size

 

Reduce preload force
F (P, C, NL*)
[kN]

Modified torque method
Torque moment
M (A, L)
[Nm]

Modified combined method* (torque + angle)
Pre-torque moment
M (A, MKV, NL
[Nm]

NL12SC 45 130 100
NL16SC 90 330 250
NL20SC 145 660 490
NL22SC 170 850 640
NL24SC 200 1100 825
NL27SC 260 1600 1220
NL30SC 315 2150 1650
NL36SC 460 3750 2800
*Torque conditions are specified in the ETA-13/0246 for HV bolts, grade 10.9

Tightening Angles

t < 2d 45° 1/8
2d ≤ t < 6d 60° 1/8
6d ≤ t ≤ 10d 90° 1/4
10d < t No recommendations
*Tightening angles when using the combined method varies depending on the clamp length, t, in relation to bolt diameter, d.

연락하기

사용자 정보 취급 방식에 대한 자세한 내용은 개인 정보 취급 방침을 읽어보시기 바랍니다.

연락해 주셔서 감사합니다!