Straight Pin, Through Bolt - For New Machine Installation
Follow the installation instruction to ensure that the Expander System is installed correctly and to prolong the pivot life.
Expander System will perform as expected from the moment it is installed until the end of its intended lifecycle. Each Expander System comes with a function warranty of 10 years / 10 000 hours in operation (whichever comes first) from the date of purchase.
This instruction is valid for lug holes with the following maximum tolerances:
- Hole tolerances: H9
- Lug hole inner surface roughness: Ra 3.2
- Misalignment of lugs: Outer lug distance/500
- There should be no bushings in the lug ears
If your lugs are not within these specifications, please consult your dealer or Expander System for installation recommendation.
1. Bolt 2. Washer 3. Sleeve 4. Axle (Pin) 5. Expander flat headed nut for internal hexagon
Grease the sleeves and axle, preferably graphite grease.
NOTE! If applicable: position greasing outlet 90 degrees to force direction to minimize stress concentration at outlet.
Install the Expander System assembled. Position it in the bores and tighten the fastener. Hold the washer with a plier to prevent the axle from turning. Torque as specified.
Torques M12-M24 ± 10%, M30... +30/-0%
After initial torque move machine through full range of motion several times and recheck torque.
Ensure that there is a minimum distance of 0,5 mm (.02”) between the washer and the lug. ATTENTION! If the washer is in contact with the lug contact your dealer or Expander System.